In the pictures, I need to replace the interior slideout seal. It is hard to see in the photo, but the lower 2 feet or so of the rubber seal is no longer attached to the metal channel. It is ripped where they meet.
It appears to just slide into the metal channel (on the aft side) that is...
Hello,
Here's a bit of a long-winded troubleshooting story, just in case any of you run into this issue.
Our 2021 Imagine 2070RL has an 11-foot Schwintek kitchen slide that suddenly decided to move in/out a mere 1/2" at a time and then cancel. The only way to get it to continue moving was to...
I’m having a lot of trouble trying to find a video or decent instructions on how to manually extend or retract the slideouts on a 2022 Sanibel 3802WB. The dealership provided a crank shaft/bar but I have no idea where it goes.
Videos I have found said you insert it thru a hole in the slide out...
Our lippert panel is randomly not seeing our dinette slide.
Everything says to check the communication module but we cannot locate the end near the slide.
And does anyone know how to manually get the slide back in to take to get checked out?
We have a 2018 Forrester 2401r MBS and would...
I saw a thread on this in the past, but no cause/ solution was ever revealed. The OP said he had the factory make an adjustment.
On a 2020 I5, full-wall slide, there is a significant gap at the bottom when fully closed. The gap is more pronounced at the rear.
The slide is fully closed at the...
While re-attaching the paneling on the back of the dinette seat on my 2017 Shamrock 21ss I noticed, after pulling out the couch, there was light coming into the inside of the slide-out between the floor and the wall. Upon closer inspection there is a fairly large gap between the wall and floor...
This may be a long shot, but here goes. I own a 2016 28DS, with a folding king size bed. The bed slide goes out of the back of the motorhome. On the right underside of the bed platform inside the bedroom, is an "e chain" thru which wiring runs. Photo is included. The mounting bracket on the e...
I have a 2019 Cedar Creek 29RE that the table slide out opening in the trailer wall appears to be a parallelogram and not a rectangle as it should be. I have leveled the slide per Lipperts instructions. While going in or out it rubs along the top left corner and the bottom right corner looking...
I have a 2016 rockwood 8328bs and I'm trying to adjust one of my slide outs. It's an electric through frame assembly, about 10' long and has the kitchen, entertainment center and outdoor kitchen in it. (It's super heavy)
I noticed the flush head assembly on the passive side only connects to...
Recently had the “mysterious flashing lights” under my slide out. Solved that problem. When I pulled the slide out in, I can see the controller on the back wall of the slide out. Sadly at this location it is just out of my reach to override the controller if needed, but I can use a coat hanger...
So we just had this unit in getting a complete new vinyl floor in and they removed the back bedroom slides. Since those were out we told them to replace the seals on the slides. The one slide seal look like they are ripping already and will not fold out. Waiting to bring unit back in for them to...
I have a 2015 27 foot Avenger and noticed the wall in the bedroom is bubbled out. This is at the bottom corner of the slide out.
How do I diagnose this then fix it?
A couple days ago, the RV next to mine was struck by lightning. The electrical surge traveled to my service pole and fried my surge protector. So far, everything works fine, but the slide and awning extend buttons on my Firefly VegaTouch Mira panel are locked. Everything else on my panel works...
We have a 2022 Georgetown 36B5 with 3 slides using the Lippert Slimrack. Two of the slides are working without issues but the bedroom slide is not working properly.
When making the slide go either in or out, it will work for 2 inches then stop. Then again 2 inches and stop. I have to do this...
Hey,
My RV guy replaced my power panel and all worked for about 2 month and now he is on vacation. My slideouts have no power everything else works, guessing it’s a fuse but I don’t know which one? Also I believe I have 2 fuse boxes one in the panel and one somewhere else? Any hits are...
Hey,
My RV guy replaced my power panel and all worked for about 2 month and now he is on vacation. My slideouts have no power everything else works, guessing it’s a fuse but I don’t know which one? Also I believe I have 2 fuse boxes one in the panel and one somewhere else? Any hits are...
Hello All,
I wont go into details now.
Urgent I discover how to Manually extend Drivers side "Couch and Refrigerator" slide.
I need this information ASAP.
It appears to be a rack and pinion system. I located a Crank tool. But before I get myself into a bind, I'm reaching out for advice...
I bought a 2020 Columbus 366rl new and have always had issues moving the SuperSlide, the large one with the kitchen appliances. Generally it moves out but had problems new lifting and pulling in. The repair shop said it’s just the bad design. I asked to modify the hydraulic pump or add an...
2021 forest river sierra, model 379 flok. Slide room 3 is binding up when we put it out. Went in fine at campground this morning but when we got home the right side is binding up. There are no obstructions.
We have a 2020 Flagstaff 26FKBS with a Lippert through the frame slide. After our last trip, where we encountered more then a few rough interstate highways, the slide has developed a nasty rattle when it's within a few inches of being fully retracted.
After a few hours of troubleshooting it...
I know this was talked about in a old post from 2020 but anyone still having issues?
2019 FR30Ds here and yesterday my LR slide decided to, 3 days before vaca, slid in on it's own. Followed reset procedure. Got it to slide out but it decided to again retract on its own. Panel was reset twice by...
Hello, I have a 2019 Forest River Salem Cruise Lite 273 QB XL travel trailer. Everything has worked great until last week when I went in to clean some stuff after a recent trip and the slide would not operate. No motor noises, nothing. I googled for a while and then tried it again yesterday and...
Hello:
The factory installed Eternabond tape on our largest (of 3) slides now has gaps under it in places and I want to repair this before the fall rain starts. The tape on the other 2 slides is fine.
See the attached pictures showing the folds / gaps that have appeared in the tape and...
Hi Brian,
Camping World- Wilsonville replaced the rear motor for the large slide-0ut, per your E mail. for the second time on our 2022 Dynamax.
We still are afraid to use this slide-out unless we have easy access to a service center so that we don't get stuck out on the road.
Is there an...