slide

So this trailer just past its 1-year warranty period (typical) and now we're starting to see issues with the slide. I've taken it to the dealer twice now and both times they can't replicate it - it works just fine for them! Here's a video showing the issue (at least in this one the slide went...

2010 Dutchmen Four Winds 270RL. Living room slide out started dragging on carpet leaving small, residual wood chips on the carpet at both ends. Underside of slide out shows multiple, straight abrasion marks where the bottom of the slide floor has been dragging on something when going in and out...

On our Rockwood Freedom 1940, one of the end caps on the bed slide rail (which stops the bed from being pulled out too far, beyond the stop) appears to have been pulled out. First picture shows what it looks like intact, the other two pictures show the bed slide rail where this one was pulled...

Hello, I have a 2017 Forest River 31KQBTS. 36-foot bunkhouse. Hoping someone knows how to help me solve an electrical problem. On Friday, everything worked perfectly. Saturday, I loaded it up and towed it to a campsite several hours away. On arrival, all 3 slides, the power awning, and all...

Our kitchen slide has been fine since the rig was purchased new in 2021. Now it won't extend. Rig level, no sighs of misalignment. I try to manually extend it using the hand crank. No help. Gears seem ok (not opened up to see). So I open up the belly to possible see a problem. The attached...

We have a 2018 Sunseeker 2400 MBS with the slim rack slide. Slide suddenly started tipping inward when bringing the slide in. Slide will extend out and be within a 1/4 inch square with the motorhome top and bottom front to back. Might have to resync to get it that way. When retracting the slide...

Can anyone give me suggestions on how to maintain the slideout? When sliding in and out there is decent pressure and the screws to the frame are falling out. I’ll attach a picture. I don’t know how to maintain this properly and I fear it is detrimental.

I tried to search and couldn't find an answer. we have a 21 31BHD with schwintek slides for bunk room. I am always preparing for the worst. Can anyone tell me where the controller for this slide would be. I keep searching but getting tired of looking for it.

Not sure what I’m doing wrong. I noticed some of the d bulb slide seals on my 2018 272 Rl were torn in the corners and coming out of the the seal track so I replaced them all this spring. The vertical seals worked out fine but the top horizontal ones on both slides seems to have expanded to the...

To all forest River owners check your slide out motor mounts. Mine broke off this weekend.

How would you properly fix this leak? I'm getting a very little puddle inside our bedroom slide. 2 paper towels worth after a nights rain, so enough to be concerning, but not big. It looks to be coming in the corner molding. Poked at things on the outside & there doesn't appear to be any sealant...

Does anyone know where I can find my front slide controller in a 2014 Wildcat fifth wheel? My slide comes in crooked

The piece screwed to the side of the motorhome to the left of the awning mount appears to be part of the awning but I don't have a clue if it is or what it is supposed to do. Any thoughts?

Still a newbie here so please forgive my dumb question...tried searching, but have to ask. I have a 2016 Forest River Estate Villa rv with 3 hydraulic slideouts all controlled by one switch on the interior panel and one motor driving the hydraulics. Its made by Lippert. Yesterday I hit the...

New to the class c and Lippert slides. Purchased a 2013 Lexington 283TS and am doing some cleanup and PM's as well. Noticed that the slide side seals when extended have some seals still curled toward the inside of coach while others are flat against the slide housing. Is there a correct position...

Just purchased a 2020 alpha wolf and just noticed what looks like swelling in the side of slideout outside wall anyone know if this is from moister and roughly what it would cost to fix

In the pictures, I need to replace the interior slideout seal. It is hard to see in the photo, but the lower 2 feet or so of the rubber seal is no longer attached to the metal channel. It is ripped where they meet. It appears to just slide into the metal channel (on the aft side) that is...

Hello, Here's a bit of a long-winded troubleshooting story, just in case any of you run into this issue. Our 2021 Imagine 2070RL has an 11-foot Schwintek kitchen slide that suddenly decided to move in/out a mere 1/2" at a time and then cancel. The only way to get it to continue moving was to...

I’m having a lot of trouble trying to find a video or decent instructions on how to manually extend or retract the slideouts on a 2022 Sanibel 3802WB. The dealership provided a crank shaft/bar but I have no idea where it goes. Videos I have found said you insert it thru a hole in the slide out...

Our lippert panel is randomly not seeing our dinette slide. Everything says to check the communication module but we cannot locate the end near the slide. And does anyone know how to manually get the slide back in to take to get checked out? We have a 2018 Forrester 2401r MBS and would...

I saw a thread on this in the past, but no cause/ solution was ever revealed. The OP said he had the factory make an adjustment. On a 2020 I5, full-wall slide, there is a significant gap at the bottom when fully closed. The gap is more pronounced at the rear. The slide is fully closed at the...

While re-attaching the paneling on the back of the dinette seat on my 2017 Shamrock 21ss I noticed, after pulling out the couch, there was light coming into the inside of the slide-out between the floor and the wall. Upon closer inspection there is a fairly large gap between the wall and floor...

This may be a long shot, but here goes. I own a 2016 28DS, with a folding king size bed. The bed slide goes out of the back of the motorhome. On the right underside of the bed platform inside the bedroom, is an "e chain" thru which wiring runs. Photo is included. The mounting bracket on the e...

I have a 2019 Cedar Creek 29RE that the table slide out opening in the trailer wall appears to be a parallelogram and not a rectangle as it should be. I have leveled the slide per Lipperts instructions. While going in or out it rubs along the top left corner and the bottom right corner looking...

I have a 2016 rockwood 8328bs and I'm trying to adjust one of my slide outs. It's an electric through frame assembly, about 10' long and has the kitchen, entertainment center and outdoor kitchen in it. (It's super heavy) I noticed the flush head assembly on the passive side only connects to...