slide out

We have a 2018 Cherokee 274vfk. The slide out does not seem to slide completely out at the bottom. It used to slide completely flat against the inside wall. Any kind of adjustment needed to make it that way again?

Hey all, I’ve got a 2021 FR Wildwood 27RE. My slide outs work sometimes but pretty rarely. I’ve checked all the fuses and the wires running to the switches, everything looks good. I can’t figure out if this model has a slide out controller anywhere. Any help would really be appreciated.

I have a 2019 Wildcat, WCT321RLI and need to replace wiper seals. I contacted Forest River to obtain Part number. cbiddle@forestriverinc.com answered with-in a day with the following: "These are replacement seals; the original ones are no longer available. This is a one-sided seal where...

Hello all. Noticed that my slide out floor had water damagea couple weeks ago. The vacuum bonded floor had begun to droop forward at the base where it was screwed into the slide frame. This caused a break in the silicone leading to water entering at the base of the floor. In short, I removed...

On a recent short trip I noticed the wall panel above the slide on the Interior of the BunkHouse was protruding in about an inch or so. I pushed on it to put it back in place but found it was solid and could see aluminum and daylight! Went outside to inspect and found the outer skin had...

I own a 2018 Prism 2200 LE. The slide out makes cracking noises at the end of its run when fully extended. The motors seem to stop at almost the same time. I have performed a re-sync procedure (extending a few inches 3 times then fully extending and depressing the button 3-5 seconds). Any ideas?

Some of the rollers for the cable slide outs no longer roll and now have flat spots. BAL is saying they need to be replaced. Has anyone replaced these without removing the entire slide? As you can see in the photos there is not much room to work on them. DX3 37RB

I have a primetime Sanibel fifth wheel that has opposing slides in the rear. I noticed there is no manual crank accessible for the slide outs. I called so-called customer service and they told me they don’t put access panels underneath anymore because people didn’t want them. Is this really...

Not sure if anyone has had this problem, but the lower seal on our dinning room seal, the upper portion off wiper, the last 3/4 to 1 inch of wiper was broken due to flexing back and forth when slide out was moved in or out. Pretty easy to tell by looking under slide out when extended or looking...

I need to manually crank my slide out back out. There is no power to it and a puddle of hydraulic fluid underneath it not good I know. I can't find the pole that you crank on my 2005 Salem fifth wheel please help if you can thanks.

Just bought my 2021 isata 5 30 fw. I owned an isata 3 24 fw before and i am confussed. My isata 3 would open and close the slide plugged into power, running the generator or even battery only, as long as they were full charged. It wouldn't work if the engine was running. My isata 5 only works...

2018 silverback 37flk. Front living room slide only one motor seems to be turning. Looking for controller to try a reset, Any ideas?

So, have had my unit (Ultra Lite 246RKS) in my driveway after bringing it back from having something repaired. I had set it up and opened the slide out. Have never had an issue with it, but now, I get zippo response from the switch. Everything else on 12v works fine. I have ohmed the switch...

Hi there! Our family of 5 are full-timers. We were packing up this morning trying to depart our current campground when we pulled in our slide (which came in funky) and it ripped the cable slide pully system right off the wall on one side on the top. Of course we've called all the shops and...

My exterior slide seals are starting to break down on my 2015 crusader 294 RLT. that i bought back i in 2014. I Investigated replacing the seals and I discovered that the seal is all one piece. A gigantic “U” shaped one piece seal. It has an Exterior bulb then flap seal then a wall gap and...

2013 Solera and the slide isn't working properly. Controller says it is motor 2 and the code is 8 which means a wiring short. I pulled the motor and found that one of the sensor wires was frayed. Soldered it back together and replaced the motor and had the same problem. Ordered a new motor...

I can control the In-N-Out Motors by bypassing the slide button. I believe it must have something to do with the parking brake because both the awning and the slide out will not work. I have spent 3 months trying to get an answer. I am in Alaska where there are no techs as I live remotely. Any...

Hi! When we feel the inside portion of the big slide out seal with our hand, there is a portion that’s missing or kinked…anyone know how to get to that inside seal to retract it in it’s initial position, without breaking it? Thank you in advance :)

We have 2013 Rockwood Roo 23ss. My son borrowed it and one morning the wires to the battery were burnt! Was plugged into hydro at the time. He immediately disconnected battery. When he attempted to put the motorized slide out in it wouldn't work. Checked fuses etc. Are there more fuses...

Does anyone know what size or what type the gaskets are where the slide out meets the trailer?

Have a 2011 Rockwood Roo 23ss when the slideout gets in about 1/2 to 3/4 way in it scraped the floor. Checked all the brackets and everything looks tight. What am I missing? It tips down by stove , bathroom end. Any help would be appreciated. Thanks Kevin

We have a 2012 FR Wildwood 22RKS. We are the third owners and have had it and loved it for 5 years now. We were new to this “world” when we bought it. It came with a hand crank that we were told is for manual retraction of the above floor slide. The jackknife sofa is in the slide. Here’s the...

We have a 2021 FR Salem Hemisphere 24rlhl TT. It is mostly permanently parked in NC. This weekend when we got ready to leave the slide would not retract. Not even a hum like it was trying. All other power is working fine. We cut power to everything and turned it back on and that did not...

my long slide out had started to make a pop sound once when retracting then okay. Today, it would do it extending, I would stop, then move it again, and pop, repeat, until it went all the way. Kind of concerned me! I have the cable system. My auto level needs to be re-zeroed, could slight...

I have a 2015 model 176 and need to replace the slide out motor, venture sn 8772084. Has anyone taken this motor off . I removed the one 1/2 bolts from under and the motor became loose but won't slide out. Am I missing something?