frame

My 2017 forest river T21TBHW roof does not go all the way up. I have to take a pole and push it up the last four or so inches. Any ideas? Thanks.

Whenever it rains water runs along the side wall of my dormer on my A-213 Rockwood A Frame.It ends up dripping at the ledge on the front wall.Anyone experience this problem ?

I have to put a piece of tape over my furnance outside vents.Every time it rains water pours in thru these holes.Anyone else have this problem?

Tried searching but couldn't find this info... Was researching WDH options for a Geo Pro 19fbs I'll be picking up soon. Any owners out there that could tell me the dimensions of the trailer frame around where a WDH bracket would attach? Thanks!

I have a Palomino Puma; 25’ trailer. Has about 18000 - 20000 miles. Noticed crack in frame. Not sure if it’s fatigue crack, overload stress or defective material. Have others experienced this? How to fix?

A cover with vents & modifications to fit Aframe with front toy hauler rack-T12RBTHSE Our A-frame with the front toy hauler is a total of 22.1 in long , but including the spare tire on the back but it's just 18 feet not counting the front mount. We wanted to cover that would protect both the...

Our trailer was purchased new a week ago, but we were dismayed to notice that the roof assist struts were coming loose outside where they attached to the base wall. While this could have been repaired under warranty, The only repair places available could not schedule us for three or four...

Hello! We just bought a 2019 Sunseeker le 3250DSLE. We have two kids in carseats. I want them both forward facing in the dinette, with their carseats strapped in with the seatbelts and the tether anchors in back. But i can NOT for the life of me find out whether these seatbelts and tether...

First, I am new to the both the world of campers and the world of towing. Second, apologies for the long post, but trying to provide what I know to date. I have a 2020 Rockwood A213HW camper and have installed a Tekonsha Prodigy P3 brake controller in my tow vehicle. Since I have a factory...

i had the opportunity to take my batteries out and trace the 12 volt battery cables. the batteries are two 12 volt group 27 wired in parallel. after taking a good look at the battery cables i have a few questions to ask. any comments you might give are appreciated. first, there is nothing...

My 2018 Rockwood has a bent frame. It started out straight and level but over time the A frame bent. I took it to the dealer I bought it from and they took measurements and sent it to the frame manufacturer. It’s been there for 2 weeks and I called them today and they told me it’s definitely...

Does someone have a Reflection 311 bhs that can let me know the width of the door frame leading to the bunk room? I want to see if I could get a washer and dryer through the door frame. I believe I might refit the dresser using the same grey tank and water source for the exterior kitchen...

Who makes the frame for the 2509s? And have there been any issues with the frames?

Hi everyone, New to this web board, and travel trailer owner. My wife and i purchased a 2016 FR mini lite. We did some remodel. During this we found the aluminum bed frame was broke in two at the headrest side. Prior owner repaired by add 3/4 plywood on top with additional screws. Has anyone...

Hi! I have a 2018 Freelander 27QB. I was underneath the rig on the driver's side. Behind the B-Pillar, but in front of the Generator is another 12V battery sitting in a battery holder mounted to the frame. The battery is grounded to the frame, but the positive cable is routed up into the...

So I noticed that the Frame on the door side of my chalet is bent most likely from using the step to get inside. Looking for ideas on how to bend it back into place and secure it otherwise I cannot use the steps.

Been searching for an hour on the forums before posting this. The rear side fixed windows in Coachmen’s Ruby Brookstone hold water after a rain. Do I remove the window to cure or what? Thanks in advance for direction. Bill

I just finished applying the full POR15 treatment plus topcoat to my 22-year old dual axle steel boat trailer, which has been stowed outdoors in Florida for the past 16 years. I had to have the three main steel cross pieces that support the boat bunks replaced with new steel due to excessive...

I made a underfloor spare tire bracket for our toyhauler and mounted it this weekend. Basically a 2x2 tube steel and end plates, with a threaded rod and oversized wing nut and large steel plate for the washer. It was a small chore to get the tire up there, but hopefully I won't have to ever...

I haven't even camped in our A122 yet as we just got it. I have tightened loose screws, added usb ports and a voltage meter. I got a Curt BetterWeigh mobile tow scale and playing with it. So far it's very accurate as to tounge weight, trailer weight and total GCWR. Alas, waxed the body as well...

Hi. I'm prepping my Propride P3 for installation and need to measure the height of the trailer frame so I can determine how to configure the hitch bar. Unfortunately, my trailer is 10 miles away. Can someone measure the same on their late-model Mini/Micro-lite, if convenient? Thanks From...

I know there's another recent solar thread, but this is more specific. Can anyone post photos of your method/hardware to mount solar panels on the front roof of your A-frame? I am going to do one or possibly two (if they'll fit) 100W panels this year. I have seen Slim Potatohead's install on...

Hi fellow AFrame owners ~ We own a A122 and do not have any sort of canopy. Might you have a recommendation as to how we can hang a metal wind spinner without damaging the side of the AFrame? Thank you very much!: :anim_snoopy:

Hi guys, I have a solid 12V system going, but want to get at least a poor-man's simplistic 110V system via an inverter. Currently I have 2 AGM batteries wired in parallel, with 200AH. I'm running 200 watts of solar via an integrated Renogy suitcase with charge controller. I'm thinking I'm...

Hi Does anyone know what will remove the white dealer marker, from my frame? I tried scrubbing with a pad but it started to take the frame paint off. There's a dealer number and model number on the front of my frame. Any one got any suggestions please?