Fatbed on HDT

[The Bomb]

Awaiting delivery of 2119 Mack Anthem class 8 with 70" sleeper. I will be re registering it as non commercial. My plan is to lengthen the frame rails beyond axles 1-2', install a removable flatbed and haul my sandrail on truck chassie. Sand rail weight is 4,000 lbs. Then to install rear bulkhead with class V hitch to haul my bumper pull 28" toy hauler.
This will increase my "toy" hauler space and give me the ability to take 1-2 days trips without needing the trailer.

What I'm needing is guidance and help with ideas for the flatbed construction. I'm a competent mig welder and have built 2 untility trailers in the past. I'm just looking for ideas to make this a modular design so I can easily convert the truck back to it's original configuration if needed. Probably a metal frame with wooden deck to make removal lighter and easier, and bolting most substructures together instead of welding it as solid unit.

And help or ideas would be greatly appreciated.

 

[6cuda6]

I think just a standard "c" chanel perimetre frame with some "i" beam or angle iron cross bars would work spaced out every so many feet between the timber deck pieces.

So think big chanel flame each end fastebed to the frame rails, slid timbers into chanel, then slide in angle or i bean, more timbers, rinse/repeat till you cap the end at the length you want. So you basically end up with everything incased in those "c" chanels ...everything bolted together and then clamped to the rails.

 

[crushton]

I have done this to my Peterbilt 387. It is listed for sale on this forum with pictures.

 

[Weldman]

Awaiting delivery of 2119 Mack Anthem class 8 with 70" sleeper. I will be re registering it as non commercial. My plan is to lengthen the frame rails beyond axles 1-2', install a removable flatbed and haul my sandrail on truck chassie. Sand rail weight is 4,000 lbs. Then to install rear bulkhead with class V hitch to haul my bumper pull 28" toy hauler.
This will increase my "toy" hauler space and give me the ability to take 1-2 days trips without needing the trailer.

What I'm needing is guidance and help with ideas for the flatbed construction. I'm a competent mig welder and have built 2 untility trailers in the past. I'm just looking for ideas to make this a modular design so I can easily convert the truck back to it's original configuration if needed. Probably a metal frame with wooden deck to make removal lighter and easier, and bolting most substructures together instead of welding it as solid unit.

And help or ideas would be greatly appreciated.

Here is mine, it's not done as I am waiting on some left over pieces from a pole barn I am building from drill stem pipe. I used 3 inch channel iron for the framing, 6 inch channel iron to cap the ends off with, 3 inch channel iron welded to the frame of the bed then drilled holes in the chassis frame to bolt it on, stake pockets from local steel supplier, 2 inch by 3/8 thick iron for rub rail, and two quarter inch pipes one inside other for the back bumper. Reason for back bumper as such is so I can take my trailer ramps and use them on the rig too.

 

[Weldman]

More of it, I had to move the muffler so it could fit. I just cut it off at the 90 and swiveled it down, then took the chrome 90 off muffler and U bolted it to the other 90.
Lumber comes from the trees milled on our property and all fabricated with solar power from the system I built.