Can someone tell which way the wires go Left towards the washer/dryer or towards the closet before I start opening things up. As you see mice has eaten through the cable. And of course it would be on the other side of the camera plug otherwise I would just replace the camera for $150 or rewire...
OK, newbie here. I am thinking about hardwiring in a Hughes powerwatchdog into my new Dynaquest 3400 KD. Where is the best ( comvenient?) location to do this?
Thanks,
Dave
I have upgraded my trailer to 200 Ah lifpo4 batteries and I see the factory battery's system has what I assume are 2-2 stud relays with about #6-32 threads. Very low amperage. One has the charge wire from the main panel charger on the bottom stud, and the second "relay" has a similar gauge (...
HI All,
I'm getting near the end of the restoration of my 2000 Eagle. I need some advice on routing the cables behind the folding panels. The picture is of the cable entering through the roof, going behind the panels, and then disappearing through the counter to the electronics bay below...
Might it be possible to obtain the wiring schematic for my 2023 Clipper 18FQ ?
I've seen mixed discussions from other models of schematics being available or not. I'm trying to troubleshoot some things with WFCO tech support and they're telling me I can call and request the schematic from the...
Can anyone confirm the wiring for the roof on a Bronco 1251? I have 4 wires coming out of the switch at the rear of the camper.
Red
Black
White
Green
From what I can see Green must be power and White is ground for outside running lights at top of roof.
Black is power to interior 12v lights...
I have the Curt wiring harness for my 2017 Ford Flex, it has diodes to protect the cars computer but I am using the RVI brake system so can I put diodes at the plug that goes to the RV to protect the RV lighting system.
I purchased the BlueOx 4 diode kit, will this work? Or can I just put...
Hi - Can someone please shoot me a photo of their switch wiring? I stupidly forgot to take a photo before I disconnected the wires to mine. Yeah, you’d think I was smart/old enough to not make such a dumb move…
Thanks - Ned
Hello i need help with connecting my new digital thermostate. Im not 100% sure if i dod it correctly but i have 7 wires on one and 2 on the other can someone tell me what colors are suppose to go where so i dont break something i would greatly appreciate it. My main questions are why do i have 2...
I have searched Forrest River's manual/website/etc, but I'm not clear on a few things around the solar system. I do not have a solar charge controller installed, but there is a cut out spot where I can add one, and I do know the roof is pre-wired for solar and there is an SAE connector on the...
We just got a new to us 2020 wildwood 26DBUD. I'm not a fan of the white led strip under the awning. I want to switch it over to a rgb strip. I have found that the power is supplied by the control panel where the switch is. What I'm trying to find is how the power line is ran to it as it appears...
looking for some help on solar wiring for my 2019 Microlite 21DS. I have a 200W suitcase that I use with the pre-wired side port. I use an MPPT controller in the front compartment. The side port stock wiring is direct to the battery with a 20 amp in line fuse. Works great. I want to wire some...
Our 2011 DS360 suffered damage to the trailer wiring connection. There appears to be 3 types of connections- 4 flat, 5 flat and 7 pin. Would I be better off replacing the 7 pin connection and use a 4/5 adapter when using a dolly ? Or replace all 3 ?
Appreciate all of your advice over the last...
So, I attempted to clean the AC coils on my trailer today and I may have made a boo-boo during the process. Any guidance from the community is appreciated.
After removing the main shroud to the A/C unit on the roof, I was able to clean the condenser coils just fine. However, when I went to...
Reposting my reply in an excellent old thread with a general title "Lithium Batteries, are they really that expensive", which received no responses, hoping to get some feedback.
I am trying to figure out how to connect the Orion 12/12 300 TR Smart Isolated DC-DC Charger to the Battery Control...
Hello all,
I am the second owner (at least) of the above model travel trailer. My Brother in Law owned it before me and as far as I can tell the trailer was well maintained.
I have owned the trailer for about a year and its been out three times (twice by me, once by my son), all short...
Morning all,
Wondering if anyone has a wiring schematic for the 12V system, including the solar controller portion.
I currently have an issue where the fuse beside main JB near batteries keeps popping when batteries are low and we get good sun. (decent charge amperages)
To best of my ability...
I'm trying to troubleshoot an electrical issue. I have no power to the slide out from the factory connections. I replaced the control board and I know the switch works. I'm able to get it to work if I run wires from the control board to a 12v battery inside, but the wires coming through the...
So I put some lithium batteries in the rear storage compartment. I took some heavy battery cables from the house side of the disconnect switch and ran them back to the new batteries. Removed the old ones. In the compartment under the stairs I can see the 60 amp breaker for the converter, but I...
Hey all, I have a 2023 Flagstaff Super Lite 26FKBS. I recently purchased a 2022 GMC Denali 2500HD Diesel. I have pulled my RV with a 2017 GMC 1500 several times previously. Last night, when backing into a camp site, it seemed like the trailer brakes were locked up. Had a hard time backing...
hi everyone,
I am new this forum so thank you for welcoming me.
I have a 2019 Shasta Oasis 26db and I made a mistake by disconnecting the switch wiring to the awning and the slide to troubleshoot and now I cannot recall how the wiring was set up so I stop blowing fuses. Could someone please...
Not sure if this should be here or in Electrical.
My break-away switch is currently wired in after the 100a fuse on my batteries. I'm thinking it should probably be directly wired to the batteries before the 100a fuse. Is that correct?