repair

Our kitchen faucet stopped working in our 2023 wildwood fsk270 rtk. It has a black high neck faucet(no sprayer) with internal aerator. How do you get the aerator out? We got it out with a screwdriver but the valve behind it didn't come out. We have city water in all other faucets but this one...

Have a 1981 Winnebago Brave 26RH Four Season Motorhome and passing it onto our Son for his lake lot. It has a Coleman furnace, model 4334-749. A few years after purchasing the RV (second owner) the furnace gave us grief every time we tried to start it. As old as this furnace is it still has the...

Hi there. I've had a GeoPro G14FK for a couple of years now and unfortunately did not store it with a cover. My solar panel recently came unglued and blew away while on the road. Upon inspection of the roof I noticed it isn't in great condition. I don't have the funds to have it...

I had to replace some flooring in my RV due to water damage. I have vinyl sheet rollout flooring. I have replaced the flooring and glued the vinyl back down. I”m looking for a clear seamsealant. I had looked at the Roberts 7500 Vinyl seam sealer but the company that makes it says it dries white...

Did a roof inspection today, have a small tear in the roof, which material should I use to repair?

The manual crank roof vent on my Mini-Lite isn't closing correctly. It uses a pinch-type cabinet lock to secure it closed when you crank it down. That latch is pretty tight (maybe corroded?) and requires a lot of pressure on the crank to get it seated. As a result of that pressure on the crank...

Looking for suggestions on good repair facilities in Florida near Tampa or Orlando for FR3. Need to replace windshield and have a few other things checked.

The floor of the overhead cab needs to be replaced due to water damage. The rough estimate from a local independent RV service company is between $2,000 and $2,500. It sounds a little high? Coachmen Freelander Class C. Thank you

My camper Cherokee Limited 27WK The floor in front of the stove, (slide out) is soft and the plywood needs to be repaired. I took the camper to a local RV repair to see where the leak was coming from, not a plumbing issue. It only leaks when the slide out is closed. They replaced the seal...

After noticing the rollers from under our 2015 270sk’ slide out was making groves, some deep in the fiberglass we installed 5 strips of stainless steel today glued and screwed down the slide out rolls so much better. But then we noticed when the slide was all the way in 2 sections from under...

Hello. I'm starting a new thread to help document my experience having Riverstone service the growing list of issues with my 2023 Riverstone Legacy 442MC. I've started other threads based on my disappointment when dealing with the dealership and all the issues which have arisen with use of the...

Water leak Hello,so I discovered there are a few water leaks, inside my camper(365 saq 5th).It’s in the rear bunkhouse,both lower corners on the back wall.I have started tearing it apart,but there is a place for a tv and closet( sort of entertainment center),that I need to remove.I am curious...

Some of you may remember my ‘Help – Battery’ thread from 3 or 4 weeks ago. The issue was the Battery disconnect switch, since we were 3 days away from leaving on a week trip to Disney Fort Wilderness I just put both the battery cable from the switch on a single stud, eliminating the switch...

2010 Dutchmen Four Winds 270RL. Living room slide out started dragging on carpet leaving small, residual wood chips on the carpet at both ends. Underside of slide out shows multiple, straight abrasion marks where the bottom of the slide floor has been dragging on something when going in and out...

Starting project to repair as best as possible delamination on the Sunseeker Immediate scope is passenger side. Depending how it goes I may address a similar drivers side delamination yet this fall I've ordered closed and open wall kits from Composet and had my one on one project analysis...

wet pillows left a stain against the headboard area of the bedroom. How do I repair this? Can I paint, use stick on products or what is best for this?

I just picked up my trailer today from the repair shop after bending an axle in early July. I still don't know exactly how it happened but here goes my story. It was race weekend at Atlanta Motor Speedway and I was dropping the camper off on Wednesday to come back on Friday with my wife. On...

...and then how do I seal the gap between the trim and the slide out. And I'll take any advice on what to use to remove the old adhesive. It's a putty like consistency.

My Rhino 28 gallon has a crack right below the top 4" connection. The cap definitely is not leaking. What can I use to repair the crack?

Hello! I'm having issues with leaks in these two windows. Is there simply a way to replace them? Repairs haven't worked long term. Thank you!!! The top window leaks into the motorhome. The gasket used to seal it seems more like sealant rather than a gasket, and the heat has rotted it out. The...

We purchased a used 2005 Georgetown XL 326DS and the LCI Auto-leveling system has a bad valve body that connects to the Hydraulic Pump #643331 and we are now being told that Lippert has discontinued the entire assembly. No one can rebuild the valve body and there is no replacement available. Has...

I recently purchased a 2019 Rockwood A122S ESP pop-up camper. I noticed that some of the gas-strut mount screws are coming lose and the mount plate support the strut is coming unhinged. The camper has fiberglass siding. Has anyone out there with similar camper type had any issues with this? How...

Hello: The factory installed Eternabond tape on our largest (of 3) slides now has gaps under it in places and I want to repair this before the fall rain starts. The tape on the other 2 slides is fine. See the attached pictures showing the folds / gaps that have appeared in the tape and...

I have an A122 a-frame and had a tire blowout a few weeks ago. It took out the wheel well and some wiring that was on top of the wheel well. One of the wires is a 120V going from the main panel over to two outlets near the microwave. It seems the wire broke (see pictures of each end). I had...

I need some work done on my slide out and was wondering if anyone had some good experience in the Goshen area? Locally I was quoted 9 grand. That's hard to swallow.