ram

I am not sure if this is the right forum for my question but here goes. We purchased a Rockwood Mini Lite that came with the TST Tire Monitoring System. I have been trying to program the monitor. I have followed the directions 4 times now and every time I try to set the individual tire code for...

The majority of frameless window glass seals on my 2018 2604 trailer have pulled away from the corners. The factory probably pulled the seal slightly taught during installation, and over 3 years, the seals simply slid to a non-tensioned position. When I retracted a slide-out after a rain, water...

This is from the NHTSA concerning Ram Trucks---- Chrysler is recalling certain 2015-2020 Ram 1500 Classic, 2015-2016 Ram 3500, and Ram 2500 vehicles, and 2016 Ram 3500 Cab Chassis with a gross vehicle weight rating less than 10,000 lb. The side air bag inflatable curtain (SABIC) inflator end cap...

Does anyone have a power diagram for a 2021 26rr toy hauler that includes the 50 watt juice package. I've been looking at the jumble of wires and such and can't rap my head around it. I can do better reading a diagram or schematic. Planning on a solar install and need to know what I have...

Just finished a fan install. After testing a few options for 12v fans, I decided to install the Caframo Ultimate Fan. This fan is small, VERY quite and moves a lot of air. Purchased on Amazon for about $45. Installed fan above the bed, hardwired to a switch panel I had previously installed...

Are there any RV camera and blindspot detectors that directly integrate with the 2020 Ram 2500? I have the camera and tow package on the Ram.

I'm sort of tall and our kitchen is a slide out. Whenever I lean in to get coffee, open the microwave, work at the oven I seem to bump my head on the wooden frame of the slide out opening. It's a sharp corner too, so it hurts and cuts. I noticed they installed a nice foam pad on the overhead...

I have a '19 Ram 2500 gas with 8 speed 3.73. We just sold our 28' travel trailer as we're getting a great deal on a fifth wheel. The fifth wheel we are buying is a '17 Open Range m-29fbh. Pin weight 1700 lbs, dry 9k, GVWR is 11k. My truck is 3200lbs payload, 14k towing capacity...

Has anyone upgraded their mattress in their A213HW? If so, what did you buy and could you post some pictures? I think the literature said with the insert installed it is a RV King size but when I measured it, it sure looks like a regular residential King mattress. We are thinking about...

While away from home, our A213HW was broken into, the bungee broken, and having just set up find the roof and back wall no longer line up properly. Anyone know how to correct? Closest dealer is almost 200 miles from our home. The front roof bolt is now misaligned by almost 1/4 inch. With...

Hi newbie 2 questions please: Looking for a plumbing diagram for my RV and not being very succesful, Has anyone been able to find this information? Also looking to replace my heater element but not finding model for this rod.. Thanks in advance for your help...

Hello everyone, I’m hoping someone could give me some advice. We just noticed that part of one of our windows is delaminating away from the fram on one corner. The manufacturer is etched in the glass as “CLEER VISION”. Has anyone else has this issue? Any advice on what adhesive may fix this...

Hi there, I cannot seem to find the specs related to the weight max (capacity) for the playpen ramp door when it’s set up as such. Not just the ramp weight max but when it’s at up as a deck/playpen. Anyone have info on the for a 242SLC. Thanks!

I want to install a rack on my Isata to hold my kayak. I’d like to know how to obtain the roof framing schematic. And hoping also that there is a measure of where all the vents air etc are on the roof so I have dimension of open space. I sent an email to Dynamax. There phone isn’t working...

I have a 2012 Crusader 320 RLT. I don't know what each breaker switch is for and the manual doesn't have that much detail. Is it possible to get more detailed info on this rv?

I’m starting to think about any advantage of using My Ram E torque 48 V battery as an advantage for an additional power source for camping without power. Any thoughts? Just starting this for discussion.

Anybody else with a spring bar WDH with L-brackets have an issue with the link plates 'rotating' on frame, despite proper torque to specs? The link plates that hold bracket to frame are bowing, causing bracket feet to tip rearwards, not good. Mfr refuses to replace plates under warranty, says...

Simple question here: Can I leave my 12 V battery connected while I plug in my 30 Amp cord at a campground. I read the owners manual and it sounds like the voltage regulator under the dinette regulates what power you have connected

I have a 2017 Shamrock 23WS hybrid and I want to install a custom battery box on the frame between the camper body and the propane tanks. The box will extend to where I can bolt it onto the frame itself and I want to drill through the box, into the frame, tap the holes and use either 3/8-16 or...

There is some muttering on the Isata 5 FBP about an upcoming recall of the 2500/3500/5500 Cummins engine products on all 2019+ VINs caused by series of injection pump failures. Apparently in 2019 RAM (& Ford) changed to a later series and these are failing. The fix is supposed to be a...

Our 40D has 4 TV's. The front TV will program to our current cable TV hookup but the other three will not. All 4 will program to the antenna. Any ideas?

Due the bed on my truck I can't use frame mounts or bed tie downs. My last camper was able to be bolted through the floor of the camper and through the bed/truck frame. Is this possible to do? The dealer I'm talking to isn't sure if this is possible. I'm looking at a 2021 Forest River Real-lite

I have a 2013 XLR Thunderbolt 386hp12. Been full timing it all across the country for a year now. Have been using my ramp less and less because I could tell it was developing a problem. My ramp door is Crap like so many others are. It is now all but unusable. Soft and spongy at the springs. It's...

If anyone could point me to a 14FK wiring diagram that I can use to connect a new 7-pin, I would greatly appreciate it! Thank you.

Got my notice today. Surprised I couldn't find anything in this Forum on it yet. It appears the owners manual had incorrect info re lugnut torque instructions that could result in overtorqued lug nuts that in turn could result in cracks/failure of wheel studs. Not good. Fix appears to be an...