mount

Does anyone know what is the max weight of the factory mount trailer hitch on a Coachman chaparral 336tsik can carry. I want to haul a 3 wheel e bike and a 2 wheel e bike and trying to figure out what e bike carrier to use.

Hello everyone, I'm new to RV/Travel trailer-ing, I recently purchased a 2017 Coachman Clipper (17 footer) and, of course, I want to upgrade and modify everything. I have a habit of not leaving anything stock. So the first thing I want to do is mount a tv outside, but honestly, drilling into...

Hi All Mounting a TV in bedroom east west entrada mdl 295000k. Purchased tv mount the spot for the TV has a label marked TV backer is OK to use screws provided with mount. I am guessing the inside wall is constructed to accept screws. I have a stud finder. Are there TV mounts for rvs. Or can...

I want to install a outside tv mount for a 32" tv since our trailer did not come with one. I am nervous about finding the studs and drilling into the side of our fiberglass camper. Anybody have any tips? what type of mount is best? how do I find the studs? I was looking at the gostik...

We'll be driving through some mountains (Arizona, New Mexico, etc) for the first time and I'm hoping for some guidance on how they affect MPG. The worst I've gotten so far was 8.5 going into a headwind in some hilly country.

Hi, Just purchased a 2024 Geo Pro G19FD and very excited to take it out on a few short trips not to far away. One thing I'd like to do is replace the battery with a Lithium battery and mount it inside the pass-through storage. Any tips you have on running the cables inside the pass-through and...

I puchased a new 2025 2205S. The license plate bracket is just below the tail light against the rear of the camper. If I bolt the license plate to the mount, the back side of the bolts would scratch or pierce the rear of the camper. What are others doing to mount the license plate?

We recently picked up a 2025 Isata 5 30FW. Has anyone had a problem with the poop mountain forming? I believe the placement of the toilet is a major design flaw. The photo with the pen pointing is the toilet placement. Looking down the hole is only 6 to 8 inches to the bottom. The bottom photo...

At the highest point of the sun today here in the PNW I observed how my new 400w panels on trailer's roof were comparing to my portable 240w watt portable panels. Portables were set up at optimum angle for this time of year and roof panels just flat-mounted on a slightly domed roof. Here are...

My spare tire is mounted under the front triangle. After having to get it off I hate that location and just curious of other options because the only other thing I can think of is just keep in truck bed, under tonneau cover, but I don't want to give up that bed space. It doesn't fit in the pass...

Well my 19 month old 2351 finally had its first “issue”. I noticed that the large TV was moving up and down a bit whilst driving and discovered that one of the spot welds on the mounting bracket at the wall had broken. Easy to fix but easy to overlook too. You might take a look at yours. Up...

Heard a scraping noise and found the pump hanging from hoses and cables. The mount is welded to the frame with a arm that extends inward for the pump to sit on. The arm broke off of the plate that is welded to the frame. I had noticed awhile back that the pump looked like it was hanging a little...

Hi...I'm considering mounting a 105lb Predator Gen to the rear bumper, any advice, concerns, lessons learned. Thanks.

Hello, I have a 2024 wolfpack 365pack16 and wanting to mount a 42" tv in the living area. How big is the board in the wall that I mount to? Has anyone mounted a tv this big on a similar unit? Will I be alright with the harbor freight Armstrong swivel mount?

Planning on mounting my spare tire on the ramp gate of my FSX 260RT to free up room in my storage compartment. I have made a flange plate (backer) out of 3/16 aluminum double the size of the mount base and double the size of the backing plate than goes on the back (inside) of the ramp door. It...

Has anyone found an upgraded bracket to mount the pump for the hydraulic jack pump (see picture). It's a 2018 Forester 2861DS. I want to upgrade mine before it fails and cannot find a part number. A part number and a source would be greatly appreciated. Thanks! Lee R 2018 Forester 2861DS...

I have a Stromberg Carlson 255 A frame bracket to carry my generator. Generator is a Westinghouse 4500, about 100#. I can manage getting it up on it with a freind, but do not want to keep taking it down and up. Plan to run it on the tray. Ant ideas on how to mount it on the tray? I mean bolt it...

Wanting to install a TV mount on the exterior of my 2021 Palomino Puma XLE Lite 20RLC. Anyone know the best way to do this and/or the best location for the mount?

Does anyone know if there is a metal backer plate for tv mounting in the living room and bedroom on a 2024 263bhxl or is it just the stud? I have seen several other posts online saying most campers have a metal plate as the backer in the wall.

Stopping in New Hampshire on our way back from ogunquit Maine to Pennsylvania for about 5 days. One of the areas we were looking at The twin mountain KOA campground. Is this a nice area with a lot to do? Any other areas or campgrounds that you would recommend instead? Once we are at the...

Can someone tell me what the size and type bolt and nut that was used on the Spare tire factory mount. The PO of our 2017 Sunseeker 3010Ds has messed up the treads so that I am not sure what it is. I need to get a tread chaser but I can not tell what size to get since it is messed up so bad...

Thought I would give everyone a heads up when trying to mount a TV inside a 2023 Forest River wildcat FSX 270 toy hauler.... That little sticker that says "TV mount" IS NOT the correct location to mount the TV! It's supposed to be, but apparently someone just threw the sticker in the middle of...

we just picked up a 2024 Sierra 3550 BH. the tv backer was marked in the front bdrm but not the back. There is a cable hook up and power on the ceiling but not finding a good solid place to mount? would appreciate any ideas or help or if you know how i can get the schematics for our trailer...

I had a blow out the other day, so I took my spare tire off it's mount and changed the tire. I replaced the bad tire and when I went to put the spare back, I cant get the lug holes to line up with the studs. What gives?? If someone could send me a photo of how theirs is attached I would...

I have a 2014 Rockwood Signature ultra lite 8329ss. I am replacing the 32" toshiba that came with it, with a 43" LG. There are 8 horizontal mounted screws that hold the factory mount. The new tv will sit outside the built in frame. Any suggestions for a new adjustable, stable mount? Also, any...