bed

Hello, does anybody have any ideas I’m replacing those mattresses since mine are old now. I can’t afford to get them custom-made because they’re very expensive. The measurements of those bunkbeds are W46xL74x3”thick. Any ideas or links to websites will be greatly appreciated.

Hello all, Is there a particular technique for making the beds on the Travel trailers?? Sure takes lots of contortions if you ask me, any tricks out there???

With only the wife and baby we don't need the bunk beds (for now until more are delivered by storks). I'm looking at removing the useless mattresses and using the bunk area (both top and bottom) for storage. Any ideas aside from just using plastic storage bins?

Has anyone added reading light(s) in the bedroom of a Flagstaff Micro Lite 25FBLS? Sure would be nice if either person could have an individual reading light to themselves.

Hi. We have had our Shamrock about two months. Today when we opened it up to do some organizing I noticed a 1/2 inch gap in the back tent bed upper corner. My husband put Flex Tape on it for now but does anyone have a suggestion on how to fix a gap like this? It is a 2019.

I would like to replace our current bedroom vent with a power exhaust fan. I have read several articles at how much difference it will provide in lieu of just opening the vent. One article stated that some mfg's may prewire the vent area without actually putting in the power fan. Does anyone...

Anyone change how the mattress is held to the murphy frame? Mine has that "V" setup and the buckles are right under me with no way to adjust them out of the way. So looking for suggestions

Hi Folks, I'm looking to find info on adding dimmable reading lights above the bed in our 24' salem cl. 12 volt wiring must be located to tap into so I may need a wiring diagram. But any info welcome. Thanks in advance.:)

Is there a way to manually extend or retract the bedroom slide when a motor fails in a 2021 Sierra 3440BH? Thanks!

Afternoon all, I have a 2019 Rockwood 2706WS and I am sure this has been mentioned somewhere in the forums, but what size self tapping screws do you recommend for mounting the same tv brack that is on outside of rv to the bedroom tv mount location. Want to make sure :) Thanks,

Everything has been working fine and I just got a WiFi/Cell Phone Extender installed on the roof and my next trip out the 3 outlets in the bedroom (one on each side of the bed and one in the ceiling for the tv) do not work. I checked each outlet and no wires have come off and nothing is loose...

I have a 2008 Rockwood signature ultra lite elite 8313ss . We have discovered that the couch below the swing out bunk is supposedly a hideabed. We can’t figure out how to fold it out. We must be missing a release somewhere. Help!!!!!!

I have a 19ft XLR and cannot find the source of a water leak coming in my bedroom window I have caulked and recaulked the edge of the roof Had a window guy out he says it's not the window Has anyone dealt with this Any advice is appreciated

I thought I had seen somewhere on this forum but cannot find it has any installed pvc piping up under the existing gutter to prevent water from getting in the bed door. We found that the trees above our camper drop stuff that gets into the gutter when it rains and clogs the gutter the water...

We are new to our 171RBXL and were wondering how to prperly convert the dinette to a bed. Making a flat bed surface from the table was simple but arranging the cushions for some reason is impossible, we’re always left with huge gaps so impossible to make a comfortable bed. Any advice or do...

I have a Crusader 315 RST. I'm thinking of adding a roof A/C for the bedroom. Has anybody done this themselves? Is the trailer prewired for the A/C unit? What are the pitfalls, and what units do you recommend?

We extended the master slide inside our storage house to work on the dual shade that fell off in the last trip. When we brought back in the slide it made a tough clicking sound. It stopped, continued to click. We stopped and I went outside, we pushed the bottom and I leaned on the slide and it...

I'm wondering if anyone has a diagram of how to access the rear bedroom slide motor. Our bedroom slide will not retract and is showing a Fault - Motor. When calling the dealer, they stated it could even be that the motor has come unplugged or a pinched wire. We have only had this new RV a...

Hello, I have a 2018 HW27KS. The king bed is impossible to slide in/out, it takes 2 adults outside & 1 inside to make it work. I have thoroughly checked & nothing is blocking the rails. I see one roller wheel on each side rail & holes for what could be a second wheel. Does anyone know if there...

Front bed rails nearly impossible to pull out it is a struggle HELP

I just purchased a 2021 Rockwood ultra lite 2883ws but will have to wait till probably the first of Nov to take possession. In the interim I'm going to build a divided shoe box that will fit under the bed where it overhangs the frame support box. If anyone has the distance measurement from the...

I have the 2 sliding bedroom doors in my 2020 coachmen Catalina summit series 291bhs. The tracks keeps falling out of the ceiling. I am wondering how anyone fixed this problem? Or if replaced with something different?

2021 197BH model with the murphy bed up front. Has anyone taken apart the platform which folds down and the mattress sits on? Our bed is uncomfortable, feels lumpy / uneven, which I suspect is platform. Thought I would ask before I take it apart. Thanks

Hello all! Our recently purchased 2015 Palomino Sabre 34REQS has one of the four slides that is obviously misaligned with a 1” gap at the forward end of the slide. The 7ft bedroom slide (Schwintek?) looks to have an adjustment coupler, but when loosened, I am unable to manually square-up the...

Hello, I tried searching and could not find anything. We have a 2017 DX3 BH. We just got to our camp site and we can not extend the jacks or extend the bedroom slide. The equalizer panel says that the parking brake is not engaged. The light on the instrument panel indicates it is engaged...