TANDEM DRIVE/SINGLE DRIVE - DUAL TIRE/SINGLE TIRE
With the help of these forums I have acquired a rig to start an
RV-Garage project. With Bennett Law Office I got a Montana
registration as a private truck, not an RV yet, and with Progressive
Direct Insurance got very reasonable PL/PD insurance. I have been
driving this KW T2000 around the country getting ideas on conversions,
frame stretch, etc. With the bob tail tractor as received (Cat C12
engine, Freedomline 12 speed overdrive transmission, 3.21 rear ratio)
got about 10.5 miles per gallon. After removing the extra about 1.5
ft cab top got about 12.5, then after removing the 5th wheel and the
inside dual tires got 14.1 mpg; this is all trying to hold to about 60
miles per hour.
We have decided not to convert to a single drive axle; the tandem rear
suspension is just too solidly done and with anti-lock brakes that
work we'll keep the tandem drive.
Now for some help please. Has anybody ran or seen run only the
outside wheels of a dual pair? Running only the outside wheels of the
dual pair looks lean and mean and improves fuel economy. We did not add any spacer; just clamped the outer wheel up against the brake drum.
Our load on
the tandems will be less than half of the 40,000 lb design capacity,
so the single tires will not be overloaded and the total weight on the
wheel bearings will be less than half their design capacity but will
running only the outside wheel instead of the dual pair on each axle
result in a problem with the wheel bearings back there, sooner or way later? Don't need
the Michelin Xone super single for the light load we'll have. Comments please.
medent, 915-351-9139
With the help of these forums I have acquired a rig to start an
RV-Garage project. With Bennett Law Office I got a Montana
registration as a private truck, not an RV yet, and with Progressive
Direct Insurance got very reasonable PL/PD insurance. I have been
driving this KW T2000 around the country getting ideas on conversions,
frame stretch, etc. With the bob tail tractor as received (Cat C12
engine, Freedomline 12 speed overdrive transmission, 3.21 rear ratio)
got about 10.5 miles per gallon. After removing the extra about 1.5
ft cab top got about 12.5, then after removing the 5th wheel and the
inside dual tires got 14.1 mpg; this is all trying to hold to about 60
miles per hour.
We have decided not to convert to a single drive axle; the tandem rear
suspension is just too solidly done and with anti-lock brakes that
work we'll keep the tandem drive.
Now for some help please. Has anybody ran or seen run only the
outside wheels of a dual pair? Running only the outside wheels of the
dual pair looks lean and mean and improves fuel economy. We did not add any spacer; just clamped the outer wheel up against the brake drum.
Our load on
the tandems will be less than half of the 40,000 lb design capacity,
so the single tires will not be overloaded and the total weight on the
wheel bearings will be less than half their design capacity but will
running only the outside wheel instead of the dual pair on each axle
result in a problem with the wheel bearings back there, sooner or way later? Don't need
the Michelin Xone super single for the light load we'll have. Comments please.
medent, 915-351-9139