How to Reset the level switch

[rjdhomes]

Jason, could you please post the proper procedure for resetting the level switch.

 

[Bigfoot Leveler Staff]

Well I would be glad to do that for you here goes.

step one: turn the control panel on using the system power button and wait for the system to do the diagnostic test (15 to 30 seconds).

step two: now press the button that is labled front 5 times then press the button labled rear 5 times (at this point all the lights on the panel should be flashing).

step three: at this point you are in zero mode (or manual mode) you can now operate each jack induvidualy just like you can in manual mode, first put all jacks down so that they are on the ground. Once you have done that you can level front, rear, left, right, just by running the jacks in pairs (always run in pairs when they are on the ground).

step four: the best place to level the coach is from your freezer, so get it level where you want it.

step five: now that you are level press the button labled retract 3 times now all the lights on the panel should go out exept the air dump light it will flash for about 15 seconds then it will go out and the green bigfoot light will start to flash. at this point it has taken the new program. now just press the auto button again and it will retact the jacks and put them back down automaticly and when it is done recheck your level.

well that is how it is done if you go to our new websitewww.bigfootleveler.comand click on the system installation manual you can down load our new trouble shooting and reprogramming guide, well i hope this helps if not please give me a call anytime.

Thanks Jason

 

[rjdhomes]

Jason, Thank You, The new webpage looks great.

Bob