Search results

The existing wood was broken and only on the back half of this rail. So, I replaced it with a new piece of lumber, and cut a slot so it would fit above the bed and give it a little extra support where the bend is.

I used the existing wood, but cut a slot so it would fit when I pushed it forward about a foot (to support the front part of the roof where the bend is).

Here is the frame after I hammered upwards, reinforced with JB Weld, 90* angles, and mending plates.

Here is the bent frame under the bed on the driver's side.

do you mean sanding the edge? i'll have to replace the 1x4 cuz it broke a few feet off

We Replaced the door that the CHP smashed in.

Canvas is still intact.

sitting in the tow yard

This is the rear bottom, where the D-Ring ripped out of the rotted wood