Search results

final shot...complete

new vinyl to match the floor....same as my office...;)

Commercial pemko threshol trimmed for installation ....holds down the back edge of the carpet and provides a 3/8" riser for the door to close against

new commercial carpet installed

masking installed for the bottom section finish coat...note the masking tape hangers...in place to hold the masking paper flap out away from the body to help avoid overspray on the top section already complete.

rear shot lights ablaze

rear area filled and sanded...ready for masking

completed paint with clearance lenses installed....nice and clean

Stairs in the up position with the trailer hitch installed...ready for the boat

A thin layer of teflon was installed on top of the stinger for the stair assemble to slide on as it folds into the confined area.

all parts just to the edge of the tailgate

Two steps down with the modified third step still in the up position. It was shortend to ride over the top of the stinger extension off the reciever.

Notice how all parts extend just to the edge of the tailgate. The stinger was calced out to take the weight of the tongue of my boat...310#...calcs done to 400#.

All three modified steps extended. With 100# in the bags the stairs set up 4" off the deck.

This is the greywater tank with the modified stair assembly on the deck fitted for the 2" reciever

Notice the lining of the area. It's the steel skin off of a refrigerator cut and fitted into the refer hole to give a little extra protection in case of a fire. the caulking is fire caulking...along every seam and around the outlet...with a metal cover.

This is the upper section and cooling sinc with the two computer fans for assistance in removing the heated air from above the refer and off the coils