Search results

Stainless Steel kitchen. Framed in hardwood and sheathed in stainless. Butcher block countertops, dishwasher, full size stove

Barn door

Bathroom countertop

Tiled in a shower

Then we put up a full tongue and groove ceiling

We gutted it and replaced subfloor

I havent forgotten about y'all. Heres some far less detailed updates

End of Week 3: Engine Work Got a CHK ENG light on my way home, and I bought the truck with two other known failures (WHEEL SPIN and TRACTOR ABS FAIL) that needed to be remedied. Also felt low on power. First shop (RV place) ran codes for 2 failed injectors and said they couldn't work on a 55...

Plywood is delaminating below the kitchen window, but its only the top layer. I plan on placing tile over it, so I think I can scrape off the top layer of delaminated plywood and spackle over it.

Pulled the wallpaper and rotted plywood. Will patch after all the damage in the RV has been found. May need to widen the cut to reach the aluminum frame. The frame will allow the patch to be securely anchored to the wall

Worst damage so far came from an exterior outlet. Bottom picture shows a complete lack of caulking around it.

This was a very lightly damaged area. Water stains under window, no mold/rot/soft spots - Not sure if I should cut out the panel, sand it, spray with mold killer or just paint over it. Let me know what y'all think

Need to remove the cabinets to get the wallpaper behind it. You can see water damage in the top left from the slide out. Slide out is getting removed to replace broken rollers. When that is removed I'll work on the drywall behind it. Removed a lot of trim too. Need to start labeling it. Will...

End of Week 2 Update: Removed a lot of wallpaper, very difficult because its heat bonded, but in my opinion its an essential step of a good restore job. Simply painting over the wallpaper can be a waste of time because it will eventually curl up, and removing all the wallpaper allows me to see...

Replaced the subfloor panel with 5/8'' plywood, but its too thin. I know 3/4'' plywood will be too thick so I'll have to figure out a way to raise it. Need the floor to be perfect prior to installing vinyl over top.

Update 2: End of week 1 Spent the rest of the week trying to scrape up all the old adhesive from the subfloor. WHAT A PAIN! Its taken about 20 hours to remove about 90%. Scraping gets most of it but some needs to be dissolved with adhesive remover, which takes much longer.

Update 1 Frame supports confirmed good, bad subfloor panel removed. No mold/rot underneath

Panels Removed

Figured it out, reposting: Week 1: Pulling vinyl flooring Found the water damage! Plenty to go around! Luckily for me its only one panel of subfloor. Easy fix. The aluminum frame underneath is fine, so a new sheet of plywood and we're good as new! The A/C Unit above the water damage was the...

I can't get images to show on this board, they just appear as icons. The build is also logged here 04 Haulmark Restore Project - Page 2 - HDT - Escapees Discussion Forum

Trying to figure out how to post pics on this site, meanwhile I've bee posting here: 04 Haulmark Restore Project - HDT - Escapees Discussion Forum

Yes its available, contact Mike Brotherton Elite Motorsports, LLC. | Semi Transporters, Stacker Trailers, Toters, RVs | NHRA Drag Racing

Week 1: Pulling vinyl flooring Found the water damage! Plenty to go around! Luckily for me its only one panel of subfloor. Easy fix. The aluminum frame underneath is fine, so a new sheet of plywood and we're good as new! The A/C Unit above the water damage was the likely culprit here, so that...