pods8

I used 6063 too because that is what I could get in 1x1x.062 in bulk. Looks like your welder came with a CK torch, I upgraded to one...

Its a P shaped bulb seal that the leg of the P tucks in behind the perimeter trim. Someone linked this 1/4" one below in the past but...

I wasn’t aware of the Ogden location, I have been to the one on Redwood road in slc. Not sure if it’s the same franchise. That’s great...

Looks like the same franchise so I'd imagine more or less the same stuff. lots of odds and ends. :)

I'm assuming you're already aware but if not State Trailer Supply up in Ogden has a ton of supplies. It was impressive when I stopped in...

10-4, didn't know if you were on the front range here in CO, didn't immediately recognize the peaks.

That is what I ended up doing with the whole camper on mine aside from the main channel, cause I was changing so many dimensions. Where...

Imho, having an installed heater (whatever style) that doesn't require any setup is the beauty of things. Jump into cold camper and fire...

Doesn't look like they make it anymore, just an expensive 400ah with a different feature set, unless I missed it in their site somewhere.

"Two is one and one is none" is always something to keep in mind. If I needed 200ah of battery I'd get two 100ah batteries just to be...

With the prices of mid tier lithium batteries coming down to a AGM pricing I see hardly any scenarios I'd use an AGM still. Bang for...

I keep seeing mixed info on whether the block squeaks or not, esp. if all taped in place. Anyways, I got some time. I'll start welding...

Thanks for this very valuable information that gives folks a direction to research! The chart is saved to my Camper/Truck file!

Sounds strongly like I should be looking at a corrugated version on my build then...

Only time I have put on chains is in gumbo mud, that snotty stuff is ridiculous and will have you sliding slideways off a road, etc. I...