JohnK-ESC

My suggestion would be to ask the factory to install a switch between the solar panels and the controller. I have found a switch handy...

Alan, ours in not a 5.0 but since you mentioned "any vehicle", I'll just say that in 2017 we had a clear film professionally applied...

Welcome EZAdventures. We have a 2020 21C (not for sale) and are very happy with our standard 2 legged dinette. I just sent you a...

This thread would not exist had our trailers not been produced in a country which has been singled out for tariffs. Inconveniently the...

Perhaps the most profound and quotable quote of the year Dave. John

Fortunately we do not have to buy a new trailer. I’m sorry to hear that this is the Christmas present we can all expect, can’t return...

We have attended the fiberglass Quartzsite gathering only three times but hope to make it a fourth time this coming February and more in...

Had we specced out a new trailer rather than bought pre owned we would have chosen to buy new without an air conditioner as advised by...

Needing to replace a Maxxfan lift arm and operator I began by looking at my usual etrailer and Amazon sources and then saw the same...

I am 6ft 1in tall and weigh 160 lbs fully clothed. I still appreciate the lift kit for rolling around underneath on a creeper.

I installed the lift kit on our 21C for clearance protection off road on BLM back roads as well as to make it easier for me to roll...

This subject may be interesting grist for mills more geared to political economic policy than this one. I was actually thinking of...

My meter has an unfused 10 amp function position for 15 seconds as well as a mA position limited to a maximum of 200 mA. To be safe I...

My meter does have a time limited amp measuring capability so I might give that a try.

Well John that's an interesting idea and one I'd like to try, but I'm not sure I have the requisite system understanding to try. I too...