codefoster's latest activity

I'm still figuring out my new Geo Pro and found that the cable that runs from the main battery switch to the positive terminal of the...

I am doing an upgrade like this. In my research I discovered that it's better for the controller to be placed near the battery versus...

Great. Thanks for the info. I'm going to be moving to an all Victron system. I have a new Victron charge controller and BMV-712 in hand...

Yeah, by TV I meant Tow Vehicle like @5picker said. Sorry for the confusion.

I have a question about the Go Power control panel in my new trailer. It cycles through a few screens including the charge current...

Thanks, all. I decided to put it near the furnace but blowing on a person's feet if they're sitting there. That will remove the duct but...

@acadianbob, you're right that the 12V fridge would have nothing to do with the inverter. I have seen in other rigs outlets that are...

I'm going to use the Dakota charger that came with my battery to top it off now and then and make sure it gets high enough to balance...

So, is it wired up so that the only input to the main AC input of the WFCO panel is the AC line that comes from the inverter? In other...

You know what's weird is my converter is the WF-8735P but my battery is lithium. I asked the previous owner and he said he definitely...

Is it possible that pulling the fuse out isn't a good test? Perhaps you'd have to put -12V across it to simulate the true reverse...

All right, I'm blind. There was a DC label there. It still took some deciphering though. Here's what it shows for posterity followed by...

It has a label with the AC branches, but not the DC circuits like yours does. I do have a 12V fridge. Thanks for the picture of yours...

I bought a 2021 Rockwood Geo Pro 16BH. In the WFCO panel, the AC branches are all nicely labelled, but the DC circuits are not. I could...

I'm a little late to the conversion, but I like the Victron batteries a lot. They don't have a BMS which separates your concerns -...