When installing the meter you should choose a location that is easy to access. They recommend you choose a spot somewhere in your living room area.
I used 4-22 AWG wire to connect the actual meter to the shunt. Instructions say to use 16-26 AWG wire depending on the distance from the meter to the
STEP 1: AFTER disconnecting the batteries, install the shunt. This should be as close to the batteries as possible. I've seen some install the shun
Volts, Amps in use & % of full (amp hours) are the three basic metrics you receive. I prefer the amp hours % of full. You can have the full voltage
When installing the meter you should choose a location that is easy to access. They recommend you choose a spot somewhere in your living room area.
I know this isn't the cleanest looking hole. I'm quite the amateur on DIY projects and wood work. The meter is flush mounted to the wall.
This is a completed wiring install. The connector on the left runs a single negative 2 AWG wire to the negative post of the battery bank, the post on
Big Sky-JAY

When installing the meter you should choose a location that is easy to access. They recommend you choose a spot somewhere in your living room area.

There are no comments to display.

Media information

Album
Tri-Metric 2025-RV installation
Added by
Big Sky-JAY
Date added
View count
1
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top