We also added a CO Alarm under our converter housing 'just in case'!!...even though we always leave our Fantastic Fan vent open a bit when sleeping.
This is just a little tip: Not sure how many struggle with pulling on a wrench to tighten or loosen a ball nut, but here is an easy way to do it. Rot
Our welder also cut about 4 inches off the bottom of the jack tube and welded my 10" HF wheel on the end. We can now roll the trailer around in tight
We had a welding shop relocate the tongue jack rearward toward the tool box to allow the RAV4's door to swing across the tongue without hitting anythi
We also added a CO Alarm under our converter housing 'just in case'!!...even though we always leave our Fantastic Fan vent open a bit when sleeping.
Linda giving the job a few final touches. She did a very good job! We later moved the marine deep cycle battery from the front of the tongue into the
Linda is now bolting the Delta Champion tool box that I ordered 'freight damaged' on-line to the plywood board. As it turned out, the damage was easil
I these three pictures, my wife Linda is helping me install the polyurethane coated plywood surface that our tool box will be mounted onto.
Time Out

We also added a CO Alarm under our converter housing 'just in case'!!...even though we always leave our Fantastic Fan vent open a bit when sleeping.

There are no comments to display.

Media information

Category
Forest River Albums
Album
Clyde and Linda's Adventures
Added by
Time Out
Date added
View count
10
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top