The cable release for the new Valterra valve. I made my own bracket out of some scrap drilled steel strap that I had left over (rather than using the
The re-used valve, mounted within easy reach, by the Tee, near the main dump connector
The Tee connected mounted and glued (to a short length of pipe fitting into the straight coupler), with the bayonet fitting glued into the end, and th
The cable attached to the new valve. I did have to trim a few inches of the cable, which is VERY tough to cut through. I would've used my dremel, but
The cable release for the new Valterra valve. I made my own bracket out of some scrap drilled steel strap that I had left over (rather than using the
The original galley drain valve, test fitted with the 3" slip-hub and spigot flange fittings (the spigot fitting will fit into the tee piece, the slip
The front drain with the straight coupler fitted (and glued)
Cleaned up front drain, showing the gap between the Tee piece (test fitted to pipe at other end) if I didn't use a 3" straight coupler
LE

The cable release for the new Valterra valve. I made my own bracket out of some scrap drilled steel strap that I had left over (rather than using the

  • leefl
There are no comments to display.

Media information

Category
Forest River Albums
Album
8281WS Sewer Mod
Added by
leefl
Date added
View count
8
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top