A scrap piece of 1"x2" tube was welded to the front of the battery rack and then 1.5" wide 3/16" flat bar was welded to this and up to the frame above
Xantrex Inverter control panel inside motorhome. Mounted just above the motorhome control center which houses the slide, water pump and water heater
Xantrex Prosine 1000 mounted in compartment adjacent to the batteries right behind the entry door on our 378. Inverter is hard wired to the main AC p
A scrap piece of 1"x2" tube was welded to the front of the battery rack and then 1.5" wide 3/16" flat bar was welded to this and up to the frame above
1" Angle iron was laid out to hold the 4 batteries and welded together. 3/16" plate was cut for the side and is welded to the frame to hold the angle
4 of my 6 volt Trojan T-125s under the main step. Factory battery tray was cut from frame using a plasma cutter and a new tray was fabricated to hold
Angle iron was welded between the front rail and frame rail to hold batteries. Short sections of angle iron were welded to the front rail to hold bat
Closer detail of battery installation
NWJeeper

A scrap piece of 1"x2" tube was welded to the front of the battery rack and then 1.5" wide 3/16" flat bar was welded to this and up to the frame above

There are no comments to display.

Media information

Category
Forest River Albums
Album
Battery Installation
Added by
NWJeeper
Date added
View count
19
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top