10 Trim and Relocate to One Hole The factory cable plates would have left a "loop" of cable perpendicular on the roof susceptible to tree branches.
07 Mount Park Plate Mount park plate (Winegard optional part SKA-004) where roller contacts roof. Use same sealant technique as antenna.
08 Locate Control Cable Remove factory cable prep penetration sealant and unscrew plates. Pull up on cables to locate black control cable attached t
09 Trace Cables with Sounder I used a cable sounder to locate which cable was which based on the factory drawing. (note red cable ends that read at s
10 Trim and Relocate to One Hole The factory cable plates would have left a "loop" of cable perpendicular on the roof susceptible to tree branches.
11 Install Penetraton Plate Using non-sag lap sealant I installed the Winegard cable penetration plate, and covered the remaining hole with the facto
12 Secure Cables to Roof I used Home Depot cable straps and secured the cables to the roof. Use the same non-sag lap sealant in the holes. (This is
13 Install Control Box and Test On my 2014 36RL, the other end of the control cables was located in the bedroom cupboard next to the TV. This cupboa
atom ant

10 Trim and Relocate to One Hole The factory cable plates would have left a "loop" of cable perpendicular on the roof susceptible to tree branches.

There are no comments to display.

Media information

Category
Redwood media category
Album
Atom Ant SK-1000
Added by
atom ant
Date added
View count
1
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top