07 Mount Park Plate Mount park plate (Winegard optional part SKA-004) where roller contacts roof. Use same sealant technique as antenna.
04 Install Antenna Set antenna down on sealant, do final positioning, and screw it down.
05a Test Run Clearance Install dish, temporarily connect control box and do a test run to check clearances.
06 Test Run Park Test antenna store or park to check for clearances, and note where roller contacts roof.
07 Mount Park Plate Mount park plate (Winegard optional part SKA-004) where roller contacts roof. Use same sealant technique as antenna.
08 Locate Control Cable Remove factory cable prep penetration sealant and unscrew plates. Pull up on cables to locate black control cable attached t
09 Trace Cables with Sounder I used a cable sounder to locate which cable was which based on the factory drawing. (note red cable ends that read at s
10 Trim and Relocate to One Hole The factory cable plates would have left a "loop" of cable perpendicular on the roof susceptible to tree branches.
atom ant

07 Mount Park Plate Mount park plate (Winegard optional part SKA-004) where roller contacts roof. Use same sealant technique as antenna.

There are no comments to display.

Media information

Category
Redwood media category
Album
Atom Ant SK-1000
Added by
atom ant
Date added
View count
1
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Try RV LIFE Pro Free for 7 Days

  • New Ad-Free experience on this RV LIFE Community.
  • Plan the best RV Safe travel with RV LIFE Trip Wizard.
  • Navigate with our RV Safe GPS mobile app.
  • and much more...
Try RV LIFE Pro Today
Back
Top