Truck Conversion & Toterhome Community - View Single Post

Pntyrmvr · 09-21-2023, 07:04 PM

Found 3 inch cold air intake tubing on Amazon.

Had to cobble it to an old B van cold air pipe and the 2007 Aspen air box gasket yo match up with a K&N filter. Used aluminum HVAC tape to seal the joints and then covered them with black Gorilla tape for looks.

Found a PCV filter with a 3/4" ID nipple and clamp for cheap. That hooks up with a 3/4×3/4 barb fitting and a piece of curved hose off the 2007 Aspen's gas tank vent system. This way the condensed fumes will roll back into the crankcase. Amazon again!

09-21-2023, 07:04 PM	#129
Pntyrmvr Senior Member Join Date: Mar 2019 Location: GTA Posts: 155	Found 3 inch cold air intake tubing on Amazon. Had to cobble it to an old B van cold air pipe and the 2007 Aspen air box gasket yo match up with a K&N filter. Used aluminum HVAC tape to seal the joints and then covered them with black Gorilla tape for looks. Found a PCV filter with a 3/4" ID nipple and clamp for cheap. That hooks up with a 3/4×3/4 barb fitting and a piece of curved hose off the 2007 Aspen's gas tank vent system. This way the condensed fumes will roll back into the crankcase. Amazon again!