[samcrimm]

I think the NO coffee is a no go item..... You need to get that fixed!
The table is way kool for sure!

Sam

Originally Posted by Java230

Well the good news is, the 120v side of the wiring is done, bad news is it won't run my coffee maker ugh



But the table is installed!



Great time at the NWOR, we were comfortable, but had one of the most "not off road" trucks there. Either way it was nice. Hung out with lots of friends, enjoyed watching the obstacle course, and did lots of walking around looking at rigs I recognized!




Now I thought I had a leaking window..... Well its not the window...... Looks like our time on rough roads has taken its toll on the roof seams. They are splitting all the way around. Tri Van used an elastomeric of some sort to seal the overlap between the roof sheet metal and the corner extrusions. Its brushed on. Where is passes over the lip of the sheet metal it looks like it was the thinnest point and its just splitting there. Ugh!

This is the worst of split, but actually not leaking as the butyl that is between the pieces is good and thick here.


[B]SOOOOO I get to re seal it all the way around, fun.... I hit the spots that were leaking (place you can see form the interior anyway...) with a bit of sikaflex since it was supposed to rain again. I wiped it with MEK and a wire brush, seemed to stick well.