Truck Conversion & Toterhome Community - View Single Post

Kenn · 10-08-2013, 12:15 PM

I had my steel supplier shear and bend the .040 polished stainless. He can shear and bend up to 12'. I think the cost was around $750. for the material and labor. I asked that the corners be bend just past 90 and some were short of 90 so I adjusted them over a sheet of plywood on edge. I used screws every 3" to make sure it would be flat against to body. If you have some sheared use gloves as you can get cuts and not even feel it.

10-08-2013, 12:15 PM	#298
Kenn Senior Member Join Date: Sep 2010 Location: Willamina Or Posts: 277	stainless trim I had my steel supplier shear and bend the .040 polished stainless. He can shear and bend up to 12'. I think the cost was around $750. for the material and labor. I asked that the corners be bend just past 90 and some were short of 90 so I adjusted them over a sheet of plywood on edge. I used screws every 3" to make sure it would be flat against to body. If you have some sheared use gloves as you can get cuts and not even feel it.