Jbeech my mill is an old Supermax that I got at an auction for $1200 a few years ago. Also on page 10 is a picture of a friend using it to make an oil pan for his race car. I finished with the corners on all the windows. I made a template that I can clamp in the corner and then use the flush cut router bit. I also used the router to round over the sharp edges where the stainless trim will go. Now I can start putting epoxy on all the bare edges. I am changing my method of holding the FRP to the frame. I sent all of the Sikaflex adheasive back and bought six rolls of 3M VHB tape. I will now have time to get all of the bolts started and not worry about the adheasive setting-up before all the clamps and bolts are tight. One step forward and one back.
|