FRP fitting
I had to order new cutters for my mini boring bar so I can finish my drill fixtures. I have been cutting and fitting the four pieces of FRP that my sister helped me clamp in place. I started with the rear piece which is 8' x 8' and weighs 140 lbs. I was able to slide it to the side and make the cut from bottom to top and then lift it with a floor jack and cut the top edge. Much better than trying to lay the sheet down. I also cut the three pieces for the buck and walk through. It is all the correct size and in place for drilling. I will use the time waiting for the cutters to epoxy the edges of the wood.
|