the floor is in
Today I finished putting the rubber floor in the truck cab. The rear piece was rolled up in a clod room and won't lay flat. It should flatten out with a little time in the warmer shop. I put new stainless trim pieces in and they are not the same width so the cross piece sits forward just a bit. With a lot of head scratching, I was able to get the coins to line up pretty good between the two peices. Next up is to mount the speaker and run wires for them and antennas for the CB and AM/FM radios along with wires for a back-up camera. I also finished installing the air horn valve above the drivers head. I am running the air lines out the back of the cab.
|