[Kenn]

Today I finished cutting and welding the roof framing. I used .095 2" x 2" on 24" centers for the roof and the floor is .120 2" x 2" on 16" centers welded to the 4" chanel iron. On top of the .120 2" x 2" is .120 1" x 2" laying flat. The first picture is from the rear on the passenger side. Pictures 2 & 3 are showing the roof and floor frames. You can see the 14" frame for the bathroom vent. The last picture is showing how I will store the holding tank until it goes back on the rig. Next up is to cut the tack welds between the two lower sections and lift the top two sections off the truck. I might hang them from the overhead to keep them out of the way.