[KAYE RIVERCITY]

.....tape is pruchased through a 3 M supplier contact 3M for a rep[cases only].....expensive dude!.....if you use a lap seam you need to not tape in between the joints if you use screws every 4 inches....use SS marine screws with a screw gun with a pilot hole drill and a tap combined[self drilling will make you carzy].....won't slip off mark and jang the white aluminum.....lay out an aluminum screw templet to drill first or things go bad by the second row[electrical tape the back side so you don't scratch the white aluminum].....use a screwgun that you can adjust the speed and the clutch so you don't strip them out....sometimes SS are easy to break off!....if you aren't screwing it together use 2 layers of tape and heat gun for make it stick....set the sheet on a table you can adjust before you lay up the sheet-It must be level and square and you are going to need 2 guys to install.....keep wife and kids away as there is going to be some swearing from time to time-also use an plastic round or two to keep the sheet from sticking untill you are sure you have it even and square.....top is easy unless you fall off trailer....geofkaye